Raymarine SeaTalk1 to SeaTalk NG Converter Kit (E22158)
Brings older Raymarine SeaTalk1 instruments such as ST40 and ST60+ onto a SeaTalk NG network. The kit contains the converter, a SeaTalk1 converter cable, a SeaTalk NG power cable, a SeaTalk NG spur cable, two terminators and two blanking plugs. Note: The Smartboatia Hub has a standard NMEA 2000 connector. To connect it, you also need a SeaTalk NG to NMEA 2000 adapter cable with a female end.
Technical data
| System | SeaTalk1 to SeaTalk NG |
|---|---|
| Contents | converter, SeaTalk1 converter cable, SeaTalk NG power cable, SeaTalk NG spur cable, 2 terminators, 2 blanking plugs |
| Operating voltage | 12 V DC (9 to 16 V) |
| Part number | E22158 |
Product safety
Manufacturer
Teledyne Raymarine UK Limited, Marine House, Cartwright Drive, Fareham, PO15 5RJ, United Kingdom
https://www.raymarine.com/en-gb/about-raymarine/contact
www.raymarine.com
Responsible person
Raymarine Deutschland GmbH (Teledyne Raymarine), Atlantic-Haus, Zirkusweg 1, 20359 Hamburg, Germany
Phone +49 40 237808 0
https://www.raymarine.com/de-de/uber-raymarine/contact
Safety information
- Switch off the vessel's power supply before installing this product. Do not connect or disconnect equipment while the power is switched on.
- Power the converter from either the SeaTalk network or the SeaTalkNG bus, never from both sides.
- Operating voltage 12 V DC (9 to 16 V). A voltage above the maximum rating may permanently damage the unit. Do not connect to positive-ground systems.
- Protect the positive wire with an in-line fuse (5 A) or breaker if none is fitted. Make sure the product is correctly grounded before applying power.
